side circuit
英 [saɪd ˈsɜːkɪt]
美 [saɪd ˈsɜːrkɪt]
网络 侧电路; 实电路; 半面电路; 实线电路; 实线线路
双语例句
- KR: I think so, if you look at past years the clean side of the circuit seems to be the better place to start.
是的，如果你看看过去几年的比赛就会发现赛道上干净的一边更适于起步。 - Do not touch any object that could provide a current path to the common side of the circuit under test or power line ( earth) ground.
请勿接触任何会为通向被测电路的共用侧或电源地的电流提供通路的物体。 - Credibility analysis of CT secondary side short circuit.
ct二次侧短路可信度分析。 - Some high-end machines already have two or more microprocessors working side by side, as separate chips on a circuit board.
一些高阶的机器，电路板上原本就有两个或多个微处理器晶片。 - Technique to make high-density double side printed circuit board the method of punching through board
高速双面共面结构印刷电路板电特性仿真高解像度双面印刷电路板的穿通孔法制造工艺 - The Research of Power Supply of the High-voltage Side Circuit of Optic Electronic Transformer
光电互感器高压侧电路供能问题的研究 - By sharing one capacitor in the DC side, this circuit configuration can not only implement individual phase control, suppress fluctuation of capacitor voltage, but also implement the modular design.
这种电路结构不仅可以实现分相控制、降低电容电压的波动，而且易于提高电压等级、实现容量拓展，便于模块化设计。 - For the verification of two-stage current transformer, the errors resulted from the principle of the method of small current flowing the secondary side and from the primary short circuit are analyzed, and the expressions of their corrections are presented.
针对双级补偿电流互感器的检定，首先分析以二次侧小电流法实施检定的原理误差以及因一次侧汇流排形成短路匝所引入的误差，确定相应的修正值； - Using electroless plating copper or electroplate process on double-side PCBs or multi-layers rigid-flex PCBs, some metal can be deposited on the dielectric surface of PI or EP materials. The layer of metal can realize interconnection of double side circuit.
刚挠结合板孔金属化是指在双面或多层刚挠结合板中用化学镀铜和电镀的方法使绝缘孔壁上镀上一层导电金属使层间导线实现相互连通的工艺。 - Analysis of sudden DC-side short circuit of double-winding AC-DC generator s
双绕组交直流发电机直流侧突然短路分析 - Transient recovery voltage in breaking test for double line to ground fault occurred in different phase and in different side of circuit breaker
关于异相接地开断试验的瞬态恢复电压 - Current injection of AC side inductor for three-phase PFC circuit
三相PFC电路的交流侧输入电感谐波电流注入方案 - The factor can be adjusted to some extent by varying the reactance which has been connected to the LV side of the testing circuit to lower the capacity of the circuit.
试验时通常在变压器低压侧并联电抗器以降低试验系统容量，调节并联电抗器补偿度可在一定范围内调节容升因子。 - The Analysis of Step Pulse Waveform with DC Side Commutation UPS Inverter Circuit
正弦波脉冲分割电源端换相不间断电源主电路分析 - The paper introduces the work principle of electric braking of hydraulic turbine-generator unit, including generator stator side short circuit braking method, generator-transformer unit high voltage short circuit braking method and reverse connecting braking method.
本文着重探讨水轮发电机组电气制动的工作原理，分析了几种电气制动方法的特点及其应用场合，包括目前最常用的发电机定子端短路制动、发-变组高压短路制动和中小机组反接制动方法。 - It will help to reduce the harmonics if add DC/ DC power electronics circuit to the DC side of the main circuit.
在普通的三相逆变电路的直流侧添加DC/DC电力电子电路。这样的做的好处是根据系统需求输出直流电压，减少谐波。 - The gap-less MOA installed by the line side of the circuit breaker of each incoming line prevent lightning intruding waves from flashovering on interrupted circuit breaker.
提出了在断路器进线侧安装避雷器，以防止断路器在分闸状态遭雷击引起闪络的建议； - According to the AC side equivalent circuit of the three-phase three-switch Boost type power-factor-correction, the equations to realize unity power factor have been deduced and realized by Integrate-Reset-Control circuit. Based on the theory analysis, the simulation is studied.
根据三相三开关Boost型功率因数校正交流侧的等效电路，推导出实现单位功率因数所需的控制方程，并用积分复位控制电路进行实现，在理论研究的基础上进行了仿真研究。 - A Novel Secondary Side Clamping Phase-shifted Full Bridge Circuit
一种新颖的次级箝位全桥移相电路 - The time constants of the stator and rotor are given, and the complete expressions of AC side short circuit currents are obtained.
在此基础上，应用海维赛德运算微积法和叠加原理，分析了其稳态和直流侧突然短路运行，给出了定子和转子的时间常数以及交流侧完整的短路电流表达式； - By using double side line method in virtual experiment circuit, solve the complicated line of former electric circuit virtual laboratory.
虚拟实验电路采用双面布线方式，解决以往电子电路虚拟实验室连线繁杂的缺点。 - As to signal distribution unit at the secondary side, the signal reverting circuit which deals with single-phase data frames 'code scheme and the industrial Ethernet circuit structure are discussed.
在二次侧的信号分配单元则主要讨论了针对单相数据帧编码的信号还原及调理电路的软、硬件设计和工业以太网电路构成。 - It is possible that the cables at the load side of a circuit breaker can not get sufficient protection due to improper matching between the circuit breaker and the cables.
针对配电线路中存在的由于负载侧电缆与保护断路器的配合不当，使得负载侧电缆得不到有效的保护，导致电缆绝缘层温升过高引发线路短路和漏电事故。 - The algorithm for calculating ratio of port voltages in the sound signal source and side circuit is used to diagnosing short circuit malfunction of electric net in oilfield by using the analogue diagnosis theory.
针对油田电网呈树型分布的特点，运用模拟电路故障诊断理论，研究了利用外加音频信号源的端口比值分支定位法及侧距算法，实现对油田电网短路故障的自动诊断。 - The novel device makes the transformer primary side and the RC circuit form tuned circuit through the rational design of the three windings parameter of transformer, so that the harmonic energy of power grid flow into the transformer primary side.
这种新型谐波电能提取利用装置是通过合理设计变压器的三个绕组阻抗参数，使变压器原边与串联阻容电路形成调谐电路，从而使电网中的谐波电能流入变压器的原边。 - In the feed side of circuit generated the dynamics current of the total circuit in the circuit under test is sum of the point of fault current.
在电路的馈电端所产生的总的电路的动态电流便是待测电路中各故障点电流的和。 - On the hardware side, the circuit board which is composed mainly of by the ARM processor and peripheral circuits is designed in view of the hardware characteristics.
在硬件方面，结合嵌入式系统的硬件特点，设计由ARM嵌入式处理器与外围电路组成的电路板。 - The power factor correction makes the system power factor and total harmonic distortion performance well. Controller can precisely control the LED current upon primary side regulated ( PSR). It spare optocoupler and secondary side regulated control circuit.
由于前置了功率因数调整器，使系统的功率因数和总谐波失真表现良好，而基于原边控制的控制器能够精确的控制LED电流，并且省去了光耦和二次测控电路，有效的减小了体积。 - The isolation stage uses a high-frequency transformer to achieve voltage regulation, electric isolation and power transmission, uses a single phase full bridge invert circuit in the primary side and uncontrolled rectifier circuit in the second side.
隔离环节选用高频变压器，其一次侧为单相全桥逆变电路，二次侧为不控整流电路。